Concrete mixer operation steps and precautions:
Steps:
1. Turn the function switch on the column to the "automatic" position, press the start switch on the controller, and the entire operation program will automatically control the operation.
2. After the whole process is finished, it will stop automatically. If you need to stop in the middle of the operation project, you can press the stop button and then restart.
3. After pressing the start button, the display will start to show the time, slow, sand, fast, stop, fast, and the running indicators will flash on time.
4. During automatic control, all switches of manual functions must be turned to the stop position.
Operational matters:
1. Use a measuring gauge to detect the gap between the blade and the pot wall should be 3mm ± 2mm. If the gap is out of tolerance, the upper and lower positions of the blade can be adjusted to reach the specified range.
2. After each use, the stirring blade and pot should be cleaned in time. The electrical part should avoid violent vibration, keep away from water and high temperature, and pay attention to dust prevention.
Knowing how to use the mixer can better improve the efficiency of engineering work.
The structural design of the mixer directly affects the adaptability to various concretes and the strength and wear resistance of the material. Therefore, in the structural design of the concrete mixer, it is necessary to fully absorb and learn from the advantages of various mixers to continuously improve the performance and use of the mixer, and enhance the mixing capacity of the mixer.