How can we improve the service life of the mixing plant?
1. After each use of the batching plant, the relevant responsible personnel should clean and maintain the equipment
1. Clean the dust accumulation inside and outside the mixing tank wall, the concrete residue at the discharge port, the mixing shaft and the discharge door, rinse these places with water, and if necessary, add a small amount of stones and water to mix for a few minutes and then release. Wash the car, the additive tank and its supply system with water.
2. In the rainy and snowy season, the water pump, additive pump, water tank, additive tank, water and residual water and additives in the additive pipeline should be drained after the mixing station is used to prevent damage to the pump and its pipeline. At the same time, start the additive pump of the water pump and run it for 1 to 2 minutes.
2. Items that should be inspected and maintained every week for the concrete batching plant
1. Check whether the manual oil pump needs to be filled with grease.
2. Each lubrication point must be lubricated; (each lubrication point is located on the mixer discharge door shaft, each storage hopper and weighing hopper shaft, belt conveyor, machine support roller, pressure roller, roller, bearing, transmission chain, screw shaft The upper and lower bearings and the large gear of the main engine, etc.)
3. Check the wear of blades, scrapers, stirring arms, etc., and adjust the gap or replace if necessary.
4. Check whether the bolts at the connecting parts of the vibrator are loose.
5. Check the quality of the lubricating oil in the crankcase of the air compressor. Replace if necessary.
6. Check whether the contactor in the electrical appliance and the static contact of the intermediate relay are damaged or burned out.